Simulation of a Pick-and-Place Cube Robot by Means of the Simulation Software Kuka Sim Pro

Authors

  • Duško Lukač
  • Miljana Milić

DOI:

https://doi.org/10.7251/ELS1721095L

Abstract

In this work the creation of the program code for industrial robot and the simulation of a robot cell by means of the simulation software KUKA Sim Pro in version 2.2.2, is presented. Simulated and programmed is, in reality existing KUKA-robot cell with industrial robot of the type KR6 R900 sixx (Agilus) with signal connected conveyor belt. The software KUKA Sim Pro is a program for design of 3D-layouts of a plant components including KUKA-robots. On this occasion, any layouts and concept designs can be simulated and be analysed. The used components were taken from the integrated library or were partly newly created. The industrial robot KUKA KR6 R900 sixx counts to the quickest robots of the world. In this work, the simulation of the robot cell and periphery is elaborated, as well as with it, connected practical circumstances and issues with the programming of the abovementioned robot.

Downloads

Published

2018-08-08

Issue

Vol. 21 No. 2 (2017): Electronics, Volume 21, Number 2

Section

Чланци

License

Articles submitted to the journal should be original contributions and should not be under consideration for any other publication at the same time. Authors submitting articles for publication warrant that the work is not an infringement of any existing copyright and will indemnify the publisher against any breach of such warranty. For ease of dissemination and to ensure proper policing of use, papers and contributions become the legal copyright of the publisher unless otherwise agreed.