Modeling and Design of Passive Components for Flexible Electronics

Authors

  • Nikola Jerance
  • Nataša Samardžić
  • Dragana Vasiljević
  • Goran Stojanović

DOI:

https://doi.org/10.7251/ELS1216057J

Abstract

In this paper, electromagnetic modeling of capacitors and inductors for printed electronic circuits is studied. Capacitors are successfully modeled by two-dimensional finite element software. Capacitive sensor for chemical detection is proposed and tested in water. Inductors are modeled by the integrating through the currents and obtained results have been compared with 3D finite element method. A capacitive sensor and an inductor on flexible substrate were fabricated. Simulation results have been validated through measurements.

Downloads

Published

2012-06-15

Issue

Vol. 16 No. 1 (2012): Electonics, Volume 16, Number 1

Section

Articles

License

Articles submitted to the journal should be original contributions and should not be under consideration for any other publication at the same time. Authors submitting articles for publication warrant that the work is not an infringement of any existing copyright and will indemnify the publisher against any breach of such warranty. For ease of dissemination and to ensure proper policing of use, papers and contributions become the legal copyright of the publisher unless otherwise agreed.